The method of prolonging the service life of color steel tile forming machine
The method of prolonging the service life of color steel tile forming machine
Sep 30, 2022
Color steel roof tile roll forming machine in the operation process, often there will be some failures, not only affect the normal production, but also consume a lot of manpower and material resources for troubleshooting. More importantly, if the color steel roof tile roll forming machine often fails, it will have a significant impact on the performance of thecolor steel roof tile roll forming machine in the future. Therefore, the color steel roof tile roll forming machine manufacturer Seiko recommends that everyone pay attention to maintenance during use, so as to effectively extend the service life of the color steel roof tile roll forming machine. Note the following:
1. Do not operate the device above the shutdown height. For example, if the distance between the bottom of the upper and lower sliding box and each working surface is 290mm, the height behind the upper and lower die is required to add the thickness of the upper and lower bottom plate plus the thickness of the tile blank. Must not exceed 290 mm. When manufacturing molds, they should be designed according to requirements to avoid machine failure.
2. Ensure that the appearance of the color steel roof tile roll forming machine is clean. The stamping process of the upper die of the color steel roof tile roll forming machine is as follows: the input shaft is driven by the motor through the pulley, the upper shaft is driven by the large and small gears, and the upper die and the slide seat are driven up and down by the cam mechanism, so as to achieve the effect of pressure padding.
3. The rotational positioning of the workbench is mainly achieved by the gear set installed at the end of the upper shaft, the drive speed control pin gear, and the indexing positioning of the moving Geneva line installed on the hexagonal rotary shaft.
At both ends of the upper shaft, there is a reset cam conjugated with a compression cam mounted on the same shaft, and the positioning of the lower die in the working position is achieved by means of a locating rod and a locating plate. On the left and right sides of the housing, a lubrication pump is installed.
As the machine works, the tubing delivers lubricating oil to the frictional moving parts. After understanding the structure, performance and operating procedures of the machine, the equipment can be started, otherwise it must not be operated.
4. Be sure to carefully check the lubricating oil height between the slide box and the body on both sides. Color steel tile roll forming machine should be cleaned regularly, and there shall be no mud or water droplets.
Get a Quote Online