Pipe welding machines are increasingly used in the construction industry, and some large factories have introduced pipe welding machines: for example, square pipe welding machines and pipe welding machines with different functions. Now welded pipe equipment has become one of the indispensable equipment in welding plants. In terms of application, high-frequency pipe welding machines are mainly used. The high-frequency pipe welding machine will be damaged to varying degrees during normal use. The daily maintenance of pipe welding machines has become a topic of concern for people who use welded pipe equipment. Here is some relevant knowledge:

1. In the daily use of the pipe welding machine, the procedures in the manual should be strictly .

2. Before using the pipe welding machine, be sure to check whether the various parts of the machine work normally and whether any faults are found. Only when the machine parts meet the normal specifications, the machine can be run and put into production. Otherwise, it is easy to cause damage to the machine.

3. Start production after checking. During the production process of the machine, ensure that the production environment of the machine runs stably and meets normal temperature conditions. When there is a problem with the pipe welding machine, the production must be stopped, and the faulty parts must be inspected and repaired to avoid greater losses. The fault mainly includes problems such as unstable mechanical operation and poor sound. If a problem is found, take immediate action.

4. After the pipe welding machine is used to a certain extent, the machine should be lubricated and cleaned regularly to ensure that the machine meets the normal standards, so that the machine can operate normally and become easy to use. The aging parts should be disassembled and replaced in time to ensure the normal operation of the machine. When the machine is not used for placement and handling, good storage measures should also be taken, and it should not be placed arbitrarily.

What are the adjustment methods for the bad condition of the welded pipe machine? There are many bad conditions for the welded pipe machine that need to be adjusted, such as scratches, drill pipes, straightening adjustment, etc. When scratches occur, they mainly occur on both sides of the transverse and longitudinal axis of the pipe section, mainly caused by the edge of the pass of the flat and vertical rolls. At this time, we need to check whether the rolls are displaced, whether the bearings are damaged, and whether the machine parameters are adjusted. Although this is a man-made phenomenon that should not happen, it is unavoidable in reality.

Drill pipe problems with welded pipe machines are usually rare and the probability of this happening is relatively low. If this happens, it may be because of the poor rigidity of the thin-walled tube. If the tube wall is thin, it is easy to be bitten by the roller. Usually, in this case, it is necessary to check whether the bearing is damaged and whether the hole center is correct.